This leaves a Stick in the Leftover Material position. Use a Plank in the matching Material position, and pick up your Wooden Tool Binding. In here, pull the Tool Binding pattern from the Pattern Chest area on the far left, and put it in one of the Pattern positions shown below. Place each of these designed Patterns into the Pattern Chest, then open your Part Builder. Tool Binding Pattern (5 Next Patterns from the Axe Head, past the Sword Blade Pattern and various guard patterns, shaped like a small "x").Axe Head Pattern (the Next Pattern from the Shovel Head Pattern).Shovel Head Pattern (the Next Pattern from the Pickaxe Head Pattern).Pickaxe Head Pattern (the Next Pattern from the Tool Rod Pattern).Tool Rod Pattern (the first one available when you place a Blank Pattern down). For now, though, grab 1 of each of the following: You can scroll through the various output options using the Previous Pattern and Next Pattern buttons, or, in newer versions, with the buttons to the left of the rest of the GUI. Place the 5 Blank Patterns in the slot on the left, and notice that it brings up an output item on the right. Now that you know what parts you need to make, you will need to use your Stencil Table. While you're there, feel free to look at the Shovel and the Axe icons, and note the required parts for those. Notice, in the information panel on the right side, that it requires 1 Tool Rod, 1 Tool Binding, and 1 Pickaxe Head. Open the Tool Station and click the icon that looks like a Pickaxe. It may not seem like much, but it's enough, The first tool we're going to make is a Pickaxe made out of all Wooden parts. Place it in a space adjacent to your Part Builder, and you're ready to start making some tools!Īt this point, you should have 4 planks, 2 sticks, and 5 Blank Patterns left after all that crafting. To finish your first workplace off, craft a Chest (using 8 of the planks), then use it and 1 of the Blank Patterns to craft a Pattern Chest. Try to set yourself up such that the Stencil Table and Part Builder are very close together, but otherwise just try to keep it all close enough to be convenient for now. A Part Builder (using a Blank Pattern and the remaining log)Īt this point, you should start placing these workstations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |